No plastic parts
This pump has the same 2 gpm capacity but larger motor for heavy duty applications. Will transfer engine oil, transmission fluid, diesel fuel, antifreeze, bio-fuel etc. Fully reversible and it will run equally well in both directions. Self priming up-to 5 feet with "wet" gears. 3/8" NPT male Nickel plated
brass fittings on both sides are standard. Optional -6AN, -8AN and 1/2" Hose barb adapters available in the "accessories" page. Viton seals and Nickel plated pump housing. These pumps have been field proven and used in production military vehicles and the Navy.
Flow rate: 8LPM / 2.1GPM at 25C / 77F with SAE-30 oil, and 13mm / 1/2" ID hose. Flow rate reduced to 1.2LPM / 0.3GPM with 8mm / 3/8" ID hose
IP 67 Rating
Size: See chart below
Weight 6.3 lb
Working pressure 72 psi
Self priming (lift) to 5 feet
Run dry time, up-to 20 min
Viton seals and Fluoroelastomer lip seal
* The warranty period is 2 years from the date of purchase on the invoice.
The warranty covers only production defects
It does not cover altered, abused, or improperly installed pumps.
The warranty does not cover any installation expenses involved.
1 Review Hide Reviews Show Reviews
I installed this pump on my Duramax truck, I already had a remote oil filter setup so installing it was easy, I use it every time I start it and service intervals as the engine never starts up without oil pressure to fill the oil filters. I have similar pumps on other vehicles, if you want your engine to last and since the most wear happens on startup you need this pump.